4/1/2024 0 Comments Void pantograph makerWhen assembling do not forget to use washes were they are necessary. The pins were made with 6mm steel shafting, cut to size and threads were cut on both ends using a 6mm tap. leave the whole assembly to dry, before removing to construct the pantograph arm. through the bushes.Īfter assembly with the shafts placed one on top of the other, insert two long 6 mm pins on both sides, make sure the bushes are inserted first, they too can be fixed with resin glue so that it will not move around. at this point I will present the design that is displayed in the Photograph, The arms according to the drawing are 7/12" long from the center points of the two bushes, the 1/2 " stainless steel pipe is inserted into the hole of the bush, after the hole is drilled, when fitting I used some two part epoxy resin glue, which I applied inside the hole, it is best to assemble all four arms together, using two 6 mm shafts, which could be passed on both sides of all four shafts. If a motor is going to be used it needs to be a strong and balanced design. The most important point part of this type of engraver is, the construction of the square Parallelogram.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |